V2 · In developmentTravel Essentials
SlideID
A familiar face for your bag.
Covered luggage ID tag
Explore SlideID
Press the side tab inward to release. Support the lid as it leaves the guides completely.
V2 retention prototype
Pocket case + bedside valet
A three-zone pocket case that opens into a small bedside tray, giving everyday essentials a place to land at the next hotel or overnight stop.
- 92 × 62 × 20 mm
- One larger compartment and two smaller compartments
- Sliding lid removes completely for access
- Warm clay body with a contrasting sand lid
- Continuous lower support shelves beneath the sliding lid
- Press-in side latch with a square retaining shoulder (V2 prototype)
Not yet for sale. Physical fit and durability testing are next. Share your feedback.
A closer look at the design
Digital renders of the actual printable parts.
Press, then slide.
The revised lid has support underneath both edges and a side latch designed to resist accidental opening.
- Hold the body and press the small side tab inward toward the centre of the lid.
- Keep the tab pressed as you begin sliding the lid outward. Hold the lid as it leaves the guides.
- To close, guide the lid back in while pressing the tab. Release it fully when closed and check that it catches.
The lid is removable. It is not tethered and has no stop at full extension.
Already printed an earlier version?
Reprint both body and lid as a matching V2 set. V1 and V2 parts should not be mixed. The revised PLA standard-fit projects are ready for a test print; physical retention and cycle testing are still pending. Keep at least 12 mm of guide engagement when using the lid partly open.
Ready for a little more order?
Five small ideas for carry-ons, packing cubes and overnight bags.
Explore Travel Essentials
